DSI Systems, Inc. Antennas

Antennas


Winegard SS-3000 Amplified Indoor UHF/VHF Antenna
(Electronics) DSI Systems, Inc.

High-performance indoor antenna
Scatter Plane technology to receive indoor direct and reflected signals
Ideal for urban environments where digital signals can bounce off buildings
Compact design for any home decor
Precision-Mounted Electronics For Ultra Efficient Transfer Of Digital Signal


Price: $99.95

Antennas Answers

How do I combine the VHF signal from a UHF/VHF antenna with the signal from a dedicated UHF antenna?
my_antenna

I want to do this so that I can continue to receive a few VHF programs through my old combo antenna in the attic and get better HD TV with a new UHF antenna installed on the roof.


Just connect both antenna's to a splitter and run the single connector to you Television. Splitters can also be used as a combiners.

New Improved HDTV Coat Hanger Antenna - UHF / VHF


If you want to help save free TV - and YES it is in danger - PLEASE go to to thefutureoftv.org and voice your opinion! Let ypur politicians know ...

How do I point my uhf and vhf antenna in order to receive HD and DTV from Dallas in Rockwall, TX?
EDICS CLASS

I am located in northern Rockwall. I have a Uhf and a Vhf antenna in my attic. They are connected to a booster with an FM filter. I was recieving signals, but for some reason, I cannot seem to get any digital signals anymore.


Go to terk.com and they have a place on there where you can put in your address and it will tell you which way you should point it and what channels you can get

AntennaCraft HBU33 85 Boom HBU Series Antenna for UHF and High-Band VHF - 70 to 60 Mile Range
Antennacraft Antennas

Range Up to 60 Miles UHF Band (Channels 14-69)
31 Electronic Elements
Medium Directional Antenna for Fringe Areas
Range Up to 70 Miles VHF High-Band (Channels 7-13)
85 Boom Length

Question about DTV and uhf vhf antenna?
EDICS CLASS

I have the converter box but I lost 2 channels. Now the infomercial says you need a vhf antenna for channels 2-12 and a uhf for channels 13 and higher if you are not getting them. So do I need a UHF antenna? If I get one will I still have the lower channels. Or do I need the combo vhf-uhf atenna? Any info will help Thanks......


You use a VHF antenna for channels 2-13 and a UHF antenna for channels 14-99 and for DTV channels. Even though you select channel 7 on the remote for your DTV, you're actually watching channel 53 on UHF plus their sub-channels. VHF won't be needed after June when they stop transmitting Analog signals. The channels above reflect the stations here in the Los Angeles area.

PCT International CM2016 Channel Master Television Antenna
PCT International, Inc. Antennas

Price: $44.99 $26.40

Reception Range: Channels 7 thru 69 up to 35 Miles
Physical Characteristics-Height-36.5"
Easy Installation
Receives digital/HDTV analog UHF/HIGH VHF TV signals
General Information-Product Type-Television Antenna: Miscellaneous-Package Contents-CM2016 Television Antenna 75 Ohm Matching Transformer

Is it possible to receive HDTV broadcast using only an existing UHF/VHF antenna with a coaxial cable?
EDICS CLASS

Can any coaxial cable be used at some point connecting to a HDTV set or must it be REPLACED all the way from the antenna to the set?

Thank you.


A good rule of thumb is....if you get very good analogue reception on the antenna and coax you are currently using...then you should get good digital reception

http://www.dba.org.au/newsletter/trouble shooting.asp

Even though the above link is Australian...the information regarding antennas and reception should still be quite useful to people in most countries.

I didn't need to replace any of the antennas on my house or any coax either.

How do I build a simple VHF/UHF antenna?

Simple, external antenna instructions, please.


Indoor antennas are simple ! Out door ones are not ! Trust me ! buy yourself a ready made one from a shop !! It will save you a whole heap of buggering around sawing lengths of aluminium tubing to the correct length and bolt them onto a mast at the correct spacing and of course the rods have to be mounted the correct polarity vertical or horizontal to suit the stations you want to receive ! You will find that a VHF antenna is made with much longer rods than the UHF antenna so now we have two antennas on a mast, now do you want two down leads ? no I don't think so therefore you will need a 75ohm diplexer, that is UHF in and VHF in and only one out which goes to your TV !!. Well that describes a simple Yagi antenna ! 5 elements VHF and 10 elements UHF .. There you are then ! like I said best to go buy one !!! Cheers Pete


  • Buy Cheap Antennas

  • News

    The K7RA Solar Update

    ARRL - Sep 11, 2009

    Every August and September, I would disconnect my outside VHF antenna (to keep from receiving Terre Haute, Indiana#39;s channel 2) and hook up a pair of rabbit
    Visual Guide to ANTENNAS

    KSWT-TV - Sep 09, 2009

    You can see that they lack the part that looks like the UHF antennas shown above. This is a VHF/UHF “Yagi” antenna, which is the best type to get for any
    WAFB Channel 9, Baton Rouge, LA |Things you need to know about ...

    WBXH - Sep 09, 2009

    After the switch WAFB-DT will join WBRZ-DT using the VHF band. For best reception now of WAFB-DT a good directional UHF antenna is required in some and morenbsp;raquo;
    BearCom Introduces New BC100 Two-Way Radio

    Reuters - Sep 09, 2009

    The BC100 is provided with an antenna (UHF or VHF), spring belt clip, 2000 mAh Li-Ion battery, rapid charger base and power supply, and a two-year limited and morenbsp;raquo;
    Big Switch checklist-

    WALB-TV - Sep 09, 2009

    #39;Big Switch#39; checklist-Make sure you have a combination UHF/VHF antenna. 2. Make sure you have converted all TV sets you plan to use after The Big Switch. 3.
    WSPA Tower Shutdown Thursday Morning at 12:35 AM

    News Channel 7 - Sep 09, 2009

    One of the reasons is that dozens of stations switched their digital signals from the UHF band to VHF as they cut their analog signals Friday.
    Making Noise About DTV Received Power

    TV Technology - Aug 19, 2009

    Making #39;Noise#39; About DTV Received PowerReception of high-band VHF band DTV signals with a suitable low noise pre-amplifier. • Reception of UHF DTV signals with a suitable low noise pre-amplifier. New Orleans Station Wants Back on UHFFCC Still Clearing Up DTV Receptionall 6 news articlesnbsp;raquo;