pyramid car amplifiers

There are tow kind of power amplifiers on market, class D and class B, which one of those is the best for obtain the most bass ?

I have two 12" rockford fosgate P2 and a pyramid amplifier and it sounds great, but i'm thinking on change my amp, which one is the best for driving Bass ?

Thanks

Class d mono block all bass!

2008-07-02 19:54:47 by DaRc R

I went to a local pawn shop to see if they had any car audio so i picked up this amp for 40 bucks NOT A BAD DEAL I know it works cause i had a ...

Im looking to add to my cars audio system. I currently have all sony Explode speakers and a sony stereo. I'm now looking to add subs. A friend of mine recommended 12'' 2000 Watt DVC Legacy Red Series Sub-woofers and a Pyramid Classic 2-Channel Car Amplifier 2200 Watts. My budget is around $250 for 2 subs, an enclosure box, and amp. What is a good website to order from and what equipment will give me the best bang for my buck?

Thanks!

audiobahn

2009-06-03 17:52:19 by stevenkrahn@sbcglobal.net

Price: $135.99

High/Low Level Input
2 Ohm Stereo Stable
MOSFET Pulse Width Modulated Power Supply
Built-In Variable Low/High/Subwoofer Crossover
1000 Watts Total System Power Output

I recently installed a Pyramid Amplifier "arctic series" in my car and it went into protection mode 3days later. I started trouble shooting it and i noticed that the protection light stays on when the power,ground, and remote is connected but if I remove the power the amp powers up. Anyone with a possible answer.

Also check your ground

2007-04-29 13:23:19 by Mike

Price: $179.99 $50.52

2×1500W Max Output - 2 Ohm Stereo Stable - Heavy Duty Aluminum Alloy Heat-sink - S/N Ratio: >95DB
Two Channel Amplification - Soft Turn On/Off Circuit - Remote Turn On - Power and Protection LED's - Dimensions: 10.24''W × 2.26''H × 11.02''L
1×3000W Watts 2 Bridged - Bridgeable into 4 Ohms - Hi/Low Level Inputs - Frequency Response: 15Hz-30KHz
Fully Adjustable Electronic Crossovers - Mosfet PWM Power Supplies - High Impedance Input - THD<0.04%
Variable Bass Boost (0-12DB@50Hz) - Variable Gain Control - High Level Molex Input - Fully Protected Circuitry

I'm looking at this amp: http://www.overstock.com/Electronics/Pyr amid-240-watt-2-channel-Amplifier/328911 9/product.html#custreviews

I have a single 10" sub that I want to put in my small car.
This should push the sub right?
I don't want anything extremely loud but I want a thump that isn't there as of now.
It's a Polk Audio Sub.

http://www.amazon.com/Boss-Audio-CX150-2 -Channel-Amplifier/dp/B0016J1NNW/ref=sr_ 1_16?ie=UTF8&s=miscellaneous&qid =1235929999&sr=8-16

That one may be better?

hah
no
that amp is junk
its probably like 50 watts rms...

and we need to knwo what sub you have
do you haev a link to the type of sub you have

2009-03-01 09:42:52 by Jon G

i have a 2200watt car amplifier in my room powered by a pyramid 60amp surge power supply at 12 volts....since the amp is pulling to many amperes my question is this.....if i get another power supply of the same type can i put 24 volts through a car amplifier w/o frying it....i read somewhere that is you up the voltage it will require less amps to run.....if that wont work is it possible to use my power supply to charge a yellowtop battery while i listen to music? i have a ps-52kx PS

no dude, if you get another powersupply you can get 120Amps @ 12v, all you do is hook the powersupply the same way as the old one, do not hook it in series (neg to pos to neg to pos on amp) 24v will fry your amp, however hooking it in parrarel will double the amperage and keep 12v.

2009-07-18 14:46:20 by AnthonyB