rockford fosgate amplifiers

I sold my last system(a 600 watt power acoustik amp and 2 mtx 10's) and now I have an 800 wattx2 Rockford Fosgate Punch amplifier. I have a non ported box that holds 2 twelve inch subwoofers, I have 4 6x9 door speakers and a pioneer stereo. What two subs would hit best with my amplifier?

I agree with the last poster on alot of stuff. One good sub is much better than two cheap subs. The quality is much better and the output usually is at least on par.

I try to stick with the same brand when I can, so if you have a RF amp see what RF powers for subs with it. That should give you an idea of what the amp was designed to do.

I've also had good luck with JL speakers, especially the W6v2's, the Alpine Type R's, and lots of other good name brand subs.

2008-03-30 18:13:09 by Big Daddy

I have a rockford fosgate amplifier its the t2500 1bd im hooking it up to two t2 12s rockford fogate also just wondering if anyone has any idea if its going to sound good.

U never go wrong with Fosgate bro

2009-03-29 20:30:59 by amanda b

Price: $229.99

Four-channel amplifier delivers 75 watts at 2 ohms, 50 watts at 4 ohms, 150 watts at 4 ohms bridged mono
RCA inputs for signal level input and pass-through jacks for system building
Selectable high-pass crossover at 80Hz or variable low pass crossover at 50Hz-250Hz, both with 12dB/octave slope
The input gain control is preset to match the output of most source units
Punch Bass adjustable bass level control of 0dB/+6dB/+12dB centered at 45Hz

this amp is a small rockford fosgate 2600x series 1. on the back of it, it states- Dynamic Power: 2 x 85 Watts into 2 Ohms & RMS Power: 2 x 60 Watts into 2 Ohms. Bridged Output goes: L+ L- R+ R- B+ AP GND...i dont have the original manual and this info is straight off the amp. so what is it good for? i am trying to run 2 6x9 alpine speakers & 2 small round speakers (4inches?) and maybe a small sub. can this amp this? if not what can it handle? and does anyone know where i can find a diagram on how to connect and amp to your speakers? thanks!

if im not mistaken go to www.the12volt.com they have alot of diagrahms there have fun..

2007-10-07 14:21:14 by none

Price: $239.99

Mono amplifier with 300W x 1 @ 2-Ohms RMS power rating (150W x 1 @ 4-Ohms RMS)
MOSFET output stage and power supply
One-year limited warranty
4 Gauge power/ground terminals
Perfect for use as a dedicated subwoofer or center channel amplifier

ROCKFORD FOSGATE 1800 WATT MONOBLOCK CLASS D AMP are these amps good quality i mean has anyone heard this amp beat or own one would you recomend this amp the amp is 1200 watts at 2 ohm and 600 at 4 ohm and 1800 at 1 ohm its stable at 1 so is is a good amp

Yes, it is a very good amplifier. Class D amps are more efficient than class AB amplifiers.They can hold more punishment for a longer time than a AB. Get a nice pair of subwoofer DVC 4 ohms to wire it @ 1 ohms, just make sure they can handle 900w rms per sub.
Also with that kind of power you'll probably need to do the BIG 3 upgrade,installing 2F capacitor, or installing a high output alternator.
Wire them like this:
http://www.the12volt.com/caraudio/woofer _configurations.asp?Q=2&I=42

2007-06-21 20:40:19 by LADY CREEP G

Can i add 2,T215D4 15 inch T2 subs 4ohm to a T2001bd amp 1ohm 1 channel amp if so what capacitor should i get? Or should i add 2,T215D4 15 inch t2 sub 2ohm to the T2001bd 1 channel amp? will it all workout in my scion tc 2005? And should i add another amp to it,if so what amp?

No cap , upgrade your alternator, look into upgrading your battery , and primary wire
other wise referred to as the big 3
I would recommend contacting Powermaster for your alternator and batteries @ www.powermaster.com
and upgrading your primary wires to 0 ga.
good luck.

2008-10-13 13:57:44 by marcus b