rockford fosgate punch amp

Can anyone tell me how many watts a Rockford Fosgate Punch 120a amp puts out? There is no sticker on the bottom of the amp to tell me anymore. Plus, I cannot find anything online. Does anyone happen to know how many watts it puts out? And, tell me if the wattage output is good, fair or poor? Any help would be greatly appreciated!

Do you mean the "120.2"? Because it's 30 watts per channel at 4 Ohms, or 60 @ 2 Ohms.

2007-08-26 19:30:27 by dudeyes01

Here#39;s a sneak peek at the hottest new product line to hit the car audio industry. New Power Series amps are the sexiest amps I have ever seen ...

Just made the order for around $150 through CarDomain. I currently have a pretty old Kenwood amp that I'm hoping to replace with this to my JL 12w0 sub. How is this Rockford amp?

My boyfriend is a car audio installer and he said that the P23 is not a good amp for what u are trying to do he said go with the Alpine V12 class D ( more money but bigger bang)...Hope this helps...Good Luck...:-)

He also said and a nice set of componet speakers for your highs..

2007-04-15 17:04:43 by Thomas W. Randoph

Price: $249.99 $199.99

Mineral-filled polypropylene injection molded cone with butyl rubber surround
6.5-inch component kit with 120 watts maximum power handling (60 watts RMS)
PEI dome tweeter with integrated, concealed crossover
Flush, surface, or angle tweeter mounting options
Frequency response: 60Hz - 22kHz; 88dB sensitivity

what do i have to do to bridge it to my JL Audio W3's ? plz explane in details :)

is it safe to bridge my amp ?

Try this link,

http://www.fixya.com/support/t106725-pun ch_800a2_amp_bridge_mono

Yes, it is safe to bridge your amp, provided that you realize that it increase the chances of the amp overheating, because it is making twice the power.

2009-05-29 13:02:03 by BigBoi

Price: $219.99 $189.99

Mica injected polypropolene cone
Cold rolled steel basket
External crossovers featuring 12db LP/12db HP.
Alunimum dome tweeters
Grilles and tweeter mounting hardware included.

I am running 2 JL audio 10W7's off of a RF Punch 401s amp. The amp is 2 ohm stable and I have the subs wired in parallel for a 1.5 ohm load. The subs are 3 ohms each so if I run them in a series it becomes a 6 ohm load which I dont want. Is this half-ohm likely to cause any trouble? The majority of amps out there are only stable up to 2 ohms which will likely limit my selection when I upgade in a few months or so. The entire system is wired with 4 gauge wire and supported by a 1 farad cap so I am positive the amp is recieving good voltage. Any thoughts?

yes it is to low for the amplifier it will play but it will get hot and when the volume is loud the speaker protection on the amplifier will kick in by cutting your output to half for a few seconds or the amplifier will go on protection after a couple of minutes

2007-02-27 20:27:19 by guysmiley98465

Well, you need to look more closely at the ratings on the rockford 2400. It really doesnt do 2400 watts. That is just a rating they use to attract buyers. The RMS ratings is what counts here. Most likely it isnt more than 800w total. If you can look at the RMS specs, it wil give you a better reference to how good it will pus these subs. My guess is that I will Work, but Not power them efficiently!

2008-03-31 05:02:55 by money_bags_91