5 inch 2 way speakers

I running a Kicker 750.1 amp to 1 L710" solo baric. I know i'm going with a kicker amp for my highs. I want to use either a Kicker 350.4 or a 200.4. Since my door speakers cant be seen i willing to use a different brand for those.

1: What's a good 6.5 inch speaker that will match to either of the two amps above and wont hurt my pockets
2: Should i run all 3 ways, all 2 ways, components, or both and how should i install these into my car for best possible sound.
3. Which of the 2 amps is the best to use for my highs

I put 6.5 two way mb quarts in my ta and they sound great. One way to tell a good speaker , close your eyes and listen to the speaker for clarity and if you can tell where the sound is coming from

2007-06-26 16:39:25 by ant07

Infinity Reference 6032cf 6.5-Inch 180-Watt High-Performance Two-Way Speakers Click here for more details: www.amazon.com Infinity#39;s 6-1/2 ...

Just bought new 6.5 inch speakers and they fit into the opening but the holes dont match up 2 the factory ones. there way off. what do I do?

Hi, Drill holes to match the speakers

2009-01-07 20:12:30 by newdre86@sbcglobal.net

Price: $49.00 $22.13

Spl 1 Watt/1 Meter 90Db
Magnet Structure 40 Oz
Power Handling, Peak 200W
Frequency Response 80Hz-20Khz
Impedance 4 Ohm

So in about a year or so i'm getting a Scion Tc. I was wondering how would i wire the amps if possible. my plan was to change the 4 stock pioneer speakers to all 6.5 3 way after market pioneer speakers in the front and rear keeping the stock tweeters. Then in the trunk i plan to add 2 subs and mount in 2 6x9's in the trunk also. I plan to get a mono amp to run the subs and probably a 2 channel amp to run the 6 other speakers. so how would i wire the 2 channel amp to run the 2 6x9s and the 4 6.5 inch speakers? is it possible or would i be better off getting a 3 or 4 channel amp running 2 speakers to each channel. thanks
Also i was hoping to stick with just two amps. I plan on getting a kicker zx750.1 amp for 2 kicker CVR's, and a 150.2 or 200.2 kicker amp. I don't want to go over 1000 watts rms. Thanks.

You would be better off with a 4 channel amp for the four speakers, a small 2-channel amp for the tweets and a mono amp for the subs.

Since you're going coxial, I would use a 2-way or component instead. You don't want an overpowering of highs. A little high goes a long way.

2008-04-07 11:04:31 by lilscorpion2002

Price: $27.99

30 oz. Magnet Structure
Poly Coated Paper Cone
250 Watts Peak Power
Freq. Response 100Hz-18Hz
3/4" Mylar Dome Tweeter

I'm about to buy 4 of these speakers for my car: http://bazooka.com/products/mobile/Speak ers-C9/EL-Series-S49/ELC6502P---6-5-inch -2-way-EL-Series-Coaxial-Speaker-P92
and I am wondering would this be a substantial upgrade to a 2001 Honda Civic LX? Also, would they fit?

Any aftermarket speaker is better than stock, tho those really arent the greatest speakers...
to find out what will fit in your car go to
http://www.crutchfield.com and go to "outfit my car" it will tell you what you need
http://www.carstereoforum.net/

2009-06-14 10:47:08 by skimmer369

I have just gotten a Audio set for my car, containing a 12" sub, 760 watt AMP, 2 x 6 by 9 and some 6.5" to go in the doors. Everything has been installed except the 6.5" because apparently they wont fit and the doors will only fit 6 inch speakers. Is there any way that I can get the 6.5" 's to fit?
IF there is nothing that can be done does anyone have any suggestions to good quality 6 inch speakers?

You could just cut the hole a little bit bigger with a dremel or something

2010-01-31 23:48:34 by Brenton